APM/Pixhawk Power Module V6.0 Output BEC 3A XT60 Plug 28V 90A
APM Pixhawk Power Module with XT 60
A battery Eliminator circuit is a type of voltage regulator.it is used to prevent high voltage towards the Escās and pass the required voltage which is essential. As modern RC airplanes use high voltage batteries, it allows you to run your receiver, servos, and other accessories from your main battery without using a separate lower voltage one.
TheĀ APM 2.5.2/2.6/2.8Ā Pixhawk Power Module is a simple way of providing yourĀ APM 2.5Ā with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through aĀ 6-posĀ cable. The on-board switching regulator outputsĀ 5.3VĀ and a maximum ofĀ 2.25AĀ from aĀ 2S-6S LiPo battery.Ā The Power Module comes completely assembled with āDeansā or āTā connectors, and wrapped in shrink tubing for protection. Also, the circuit detects a sensing current aroundĀ 90 A.
Note:
The Power Module is only designed to power APM, an RC receiver, and APM accessories (GPS, 3DR radio). It is not designed to power the servos. Use your aircraftās own ESC/BEC for that.
Ā
Features:
- Voltage and current measurement configured for 5V ADC.
- Switching regulator outputs 5.3V and 3A max.
- 6-pos DF13 cable plugs directly to APM 2.5ās āPMā connector.
- Supports from 2 cell to 6 cell battery.
Original: $5.94
-70%$5.94
$1.78Product Information
Product Information
Shipping & Returns
Shipping & Returns
Description
APM Pixhawk Power Module with XT 60
A battery Eliminator circuit is a type of voltage regulator.it is used to prevent high voltage towards the Escās and pass the required voltage which is essential. As modern RC airplanes use high voltage batteries, it allows you to run your receiver, servos, and other accessories from your main battery without using a separate lower voltage one.
TheĀ APM 2.5.2/2.6/2.8Ā Pixhawk Power Module is a simple way of providing yourĀ APM 2.5Ā with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through aĀ 6-posĀ cable. The on-board switching regulator outputsĀ 5.3VĀ and a maximum ofĀ 2.25AĀ from aĀ 2S-6S LiPo battery.Ā The Power Module comes completely assembled with āDeansā or āTā connectors, and wrapped in shrink tubing for protection. Also, the circuit detects a sensing current aroundĀ 90 A.
Note:
The Power Module is only designed to power APM, an RC receiver, and APM accessories (GPS, 3DR radio). It is not designed to power the servos. Use your aircraftās own ESC/BEC for that.
Ā
Features:
- Voltage and current measurement configured for 5V ADC.
- Switching regulator outputs 5.3V and 3A max.
- 6-pos DF13 cable plugs directly to APM 2.5ās āPMā connector.
- Supports from 2 cell to 6 cell battery.
